Analog Class-H Amplifier
Its dynamic reproduction fully exploits the musical potential of almost all speakers in the field of installation and HIFI. At the same time, it is always load stable up to 2 ohms. The amplifiers have a crossover frequency with 120 Hz. with 24dB slope. For this purpose, each channel has a low-noise clip limiter. The amplifier is ventilated by two infinitely variable and temperature-dependent fans which dissipate the air flow from the front to the rear.
Careful further development and improvement in detail do not make BEC acoustic amplifiers look old even after years. Once installed, the maintenance-free amplifiers are a loyal companion for the professional user The following operating modes per channel are possible via a slide switch: Fullrange & Top, Bass
Specifications
| System | Analog Class-H Amplifier |
| Power (sin.) at 8 Ohm | 2x420W |
| Power (sin.) at 4 Ohm | 2x600W |
| Power (sin.) at 4 Ohm (bridged) | 1x1500W |
| Power (sin.) at 2 Ohm | 2x750W |
| Frequency response | 20 – 20,000 Hz |
| Rate of ascent | 35 V/µs |
| Total – distortion factor | 0,01% |
| Attenuation factor at 8 Ohm/1kHz | 350 |
| Noise voltage distance | >100dB |
| Input impedance symm. | 20kΩ |
| Channel separation | >65dB |
| Input sensitivity | 33dB/1Volt |
| Input | XLR |
| Output | SpeakON |
| Housing material | Front aluminum |
| Color | Silver |
| Height | 2 U (88mm) |
| Wide | 19″ / 482 mm |
| Depth | 358 mm |
| Weight | 15,5kg |
لا توجد تقييمات بعد.